g src="https://cdn.shopify.com/s

2021/05/21

c3820 hoover vacuums cleaners spotter Pull Dirty Water Tank front panel (E) up one inch then rotate forward so it is horizontal to floor. Use only as described in this manual. To reduce the risk of electric shock, unplug before cleaning or servicing. For an automated referral of authorized service outlet locations call, Upload manuals that we do not have and get. (See Figure 9), Step on pedal (B) to lower handle to operating position. (See Figure 19). 1.4 Remove tool and taped screw from holder. Although no cleaning solution can completely remove all spots, they can be treated by following the instructions provided by the manufacturer of the carpet being cleaned. carpet cleaner only on upholstery marked W or W/S. For full suction it is important that the front panel is properly secured before cleaning floor. Replace cap, making sure it is tight. steamvac spinscrub f5914 manualslib The Clean Water Solution Tank holds the cleaning solution that is to be dispersed onto the surface to be. To speak with a customer service representative call 1-800-944-9200; Mon-Fri 8am-7pm EST. Attach tool to hose and turn the carpet cleaner ON. Lift tool, and position it against riser. %%EOF Step on handle release pedal and lower handle to operating position; turn carpet cleaner ON.

endstream endobj 51 0 obj <> endobj 14 0 obj <> endobj 52 0 obj <> endobj 48 0 obj <> endobj 53 0 obj <> endobj 56 0 obj <> endobj 59 0 obj <> endobj 60 0 obj <>stream To avoid saturating carpet, do not use more than 4 wet strokes over any one area. 3.3 With foam strip (A) (located under the netting) in position as shown, place attachment on front of nozzle (B). (See Figure 14), Brush speed selector is turned to Spill Pick Up (see previous section). these pictures were incredibly helpful. Pull cord tight. Insert projections on holder into slots on back of cleaner. The addition of lubricant could cause damage. Fill Clean Water Solution Tank with HOOVER Detergent according to instructions on page 8. (See Figure 31), Press brush assembly firmly to snap into place. 4.17If the front panel is accidentally removed from the tank, it can be easily re-attached. The lid replaces in a hinge-like manner. In the storage position, brush roll does not shut off. Avoid picking up hard, sharp objects with the carpet cleaner. Do not clean over floor electrical outlets. Acrobat Distiller 3.0 for Power Macintosh Checking the Yellow Pages under Vacuum Cleaners or Household. Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. Remove the tank lid from the tank and empty. Ensure that the trigger is pulled the entire time. Repeat Steps 5 and 6 until the entire carpet has been cleaned. 0000007338 00000 n Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. To clean the outside of the machine, wipe off dirt with a cloth dampened in warm water and mild detergent. Pull tool slowly over carpet without pressing trigger (dry stroke). Do not send your vacuum to Hoover, Inc., Company in Glenwillow for service. When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). The Hoover SteamVac Ultra is an older model in the Hoover line of carpet and upholstery cleaners. Empty tank. Use extra dry strokes to aid in faster drying of the carpet. Sign up for our emails and texts and save. Grasp the dirty water reservoir by the carrying handle and pull up to unlock the tank from the machine. To reduce the risk of injury from moving parts, unplug cleaner. Keep detergents and other cleaners out of childrens reach. Then squeeze the trigger and begin cleaning. Use only commercially available floor cleaners and waxes intended for machine application. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or. s No adapter should be used with this appliance. Snap clip back into position making sure solution hose (N) is not pinched and moves freely. Unlatch back part of Dirty Water Tank and remove lid. Replace empty Clean Water Solution Tank and turn carpet cleaner ON. Continue to squeeze trigger and slowly pull carpet cleaner back toward you (second wet stroke). Close supervision is necessary when any appliance is used by or near children. he had been removed and which he had not; that allowed me to figure out Do not use solvent or petroleum based products to clean the machine. Lift tank off of carpet cleaner and carry it to a sink or drain. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. Questions or concerns? 4.4Replace panel with converter (F). Always disconnect cord from electrical outlet before servicing the carpet cleaner. Your HOOVER SteamVac carpet cleaner may also be used to pick up small liquid spills (1 gallon or less, never to exceed 1/4 inch in depth) on carpet, upholstery, or bare floors. (Continue using dry strokes until little water is visible passing through the recovery tank lid.

Turn cleaner over so bottom is facing up. 0000007068 00000 n To avoid wetting and possible damage to wood floors underneath area rugs/carpet, either move area rugs/carpet to a non-wood bare floor surface or place waterproof material (e.g., plastic) underneath them before cleaning. Allow carpet to dry. Comment * document.getElementById("comment").setAttribute("id","a7c2906ef936bed25390026a49263d8c");document.getElementById("afe6277d1c").setAttribute("id","comment"); Save my name, email, and website in this browser for the next time I comment. Open door on hood labeled Stair/upholstery Cleaning Connection.

0000012638 00000 n When the recovery tank is full, the automatic shut-off will engage (see page 3) and the tank must be emptied. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present. The use of an extension cord is not recommended. 5 Actual model may vary from images shown. (Do not use cleaner on wood floors.). Pour cleaner into the tank, and fill tank to the fill line with hot water. plastic) underneath them before cleaning. Then slowly pull carpet cleaner back toward you without squeezing trigger (dry stroke). If a spot is left, the stair/ upholstery nozzle is generally more effective for removing it. (See Figure 28), Grasp inner portion of brush (A) and pull brush assembly out slightly to reveal latches (B). system for my 3000-square foothome. Repeat with spray and suction. 0000002005 00000 n Then squeeze the trigger and begin cleaning. Empty Dirty Water Tank and rinse thoroughly with clean water. Make additional strokes without pressing the trigger to remove more moisture. 4.9 Position tool against the riser and slightly press it into carpet pile. Use HOOVER brand detergents; others may cause excessive foam. 4.13 Drain solution tube by placing round end in sink and raising nozzle above your head. 0000021835 00000 n (See Figure 29), Press all four latches (B) and pull brush block out. If rinsing is desired, be careful not to. G.To avoid wetting and possible damage to wood floors underneath area rugs/carpet, either move area rugs/carpet to a non-wood hard floor surface or place waterproof material (e.g. Unplug before connecting the powered hand tool (available on select models). Wait at least ten minutes. USING THIS MACHINE ON HARD FLOORS WITHOUT PROPER ATTACHMENT MAY SCRATCH OR DAMAGE YOUR FLOOR. Remove debris as shown. 0000014622 00000 n Never handle plug or appliance with wet hands. Set tanks aside. 4.15Snap clip back into position making sure solution hose (N) is not pinched and moves freely. WARNING!

Operate cleaner only at voltage specified on data plate on bottom of cleaner. Clean Water Solution Tank handle as shown. Do not expose machine to freezing temperatures. I found with that particular machine it works fine and (See Figure 4), When handle sections are completely together, squeeze trigger (A) on upper handle to snap trigger rod in place. That seemed to do a decent job too. 1.7 To store cleaning tool, open tool door, place, nozzle in bracket and fit it securely into position. The machine is pushed around much like using an ordinary upright vacuum. Keep children and pets away from carpets until they are completely dry. 0000001236 00000 n Your email address will not be published. Remove and dispose of the packaging. A temporary adapter (D) may be used to connect this plug to a 2-pole receptacle (E) if a properly grounded outlet is not available (Fig. 3.4 Push attachment against nozzle while rotating attachment downward until both ends snap into place. 0000000016 00000 n The cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. Hoover SteamVac Hoover F5810 Manual. Turn carpet cleaner on. 3.1 Squeeze trigger to release cleaning solution and slowly push carpet cleaner forward (equals one wet stroke). Store in a dry place. (See Figure 18), Turn cap (H) upside down to serve as a measuring cup. Rotate panel upward then push down until it snaps firmly in place. If you do not have access to the Spot and Stain Spray Cleaner, double the amount of HOOVER Detergent (use 2 capfuls or 10 ounces per 1 gallon. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. 0000009840 00000 n If an extension cord is absolutely necessary, use at least a 16 gauge 3-wire cord which has a 3-prong grounding type plug and a 3-pole receptacle that accepts the machine plug. 0000002122 00000 n For furniture too heavy to move, place aluminum foil or wax paper under legs. Please do not return this product to the store. 4.14Occasionally, debris may become lodged inside of the hose at the converter end (L). Squeeze trigger and push carpet cleaner forward and back several times to expel any solution remaining in the carpet cleaners system. Pretreat spots and heavy traffic areas with a carpet precleaner. Make sure lid is secure on all sides before cleaning. B.For upholstery, check cleaning code - Use your HOOVER SteamVac carpet cleaner only if the upholstery fabric is marked with a W (for wet clean) or S/W (for solvent/dry or wet clean). Any other servicing should be done by an authorized service representative. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. To avoid walking on damp carpet, start at the end of the room farthest from the door or path to sink where tanks will be emptied and filled. Follow the service center link to find the service outlet nearest you. WARNING! Press the trigger and pull the tool slowly over the carpet (second wet stroke). 0000023778 00000 n 4.6 The tank replaces in a hinge-like manner. Vacuum thoroughly.

4.8 Pre-spray the carpeted stair by holding the tool (A or B in Fig. Pin up furniture skirts and draperies. Make sure that square post (E) also aligns with square hole (F). Push bolts, into holes on front of handle, but do not add nuts, yet. If furniture must be replaced before the carpet is dry, use plastic or aluminum foil pads under legs of furniture so metal slides or wood finishes will not stain the carpet. Power Scrub for normal cleaning of carpet. Do not put any object into openings. (See Figure 16), Carry tank to a sink. Step on the release handle located on the right rear of the machine to unlock handle. Slowly move cleaner forward and backward over area to be cleaned. But deep cleaners like the Hoover go deep to loosen and remove stains, odors, and ground in dirt. 4.11 Gently press the tool onto the fabric. Rinse the Clean Water Solution Tank cap and Dirty Water Tank lid and let air dry. Do not put any object into openings. WARNING! For best results, pick up spills immediately by placing the stair/upholstery nozzle (available on select models only) just above the spill and suction up any residue on top of the carpet. Use your HOOVER SteamVac carpet cleaner only on upholstery marked W or W/S. 0000042091 00000 n Do not place carpet cleaner on stairs. Step on handle release pedal and lower handle to operating position; turn cleaner ON. Do not use the SteamVac carpet cleaner to pick up flammable or combustible liquids or chemicals. to wood floors underneath area rugs/carpet, either move area rugs/carpet to a, hard floor surface or place waterproof material (e.g. boots on carpet image by jimcox40 from Fotolia.com. Replace empty Clean Water Solution Tank and turn carpet cleaner ON. Use only on surfaces moistened by the cleaning process or small spills. This will help reduce any shading left by the carpet cleaners brushes. Hoover SteamVac Hoover F5869-900 Manual. 1).

Fill tank to fill line (J) (1 gallon) with hot tap water. This appliance is for use in a nominal 120 volt circuit and has a grounding attachment plug that looks like the plug illustrated in the sketch above. Pour one to two cups of clear water on a non-carpeted floor. Press the trigger and slowly pull the nozzle over the fabric. Always end with dry strokes. If rinsing is desired, be careful not to over-wet the carpet or upholstery. xb```b``d`c`f`d@ A; NOTE: Phillips screwdriver needed for assembly. Keep detergents and other cleaners out of childrens reach. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Authorized Hoover.

This saturates the carpet with cleaning solution. Enter your email address and check your inbox. Be sure to register your product online at Hoover.com or call 1-800-944-9200 to register by phone, 3. 1998-07-27T14:44:57 Slide tool into nozzle and remove debris as shown. Click here for our contact information. For furniture too heavy to move, place aluminum foil or wax paper under legs. Use only attachments recommended by Hoover; others may cause hazards. H\@}L9@} Q1E~aVH,mS9\>Ygionqq_(\#vpImjW<=>-[\L{9q/q/~>yMfh}05$*^[WMB7nw=%EWxzCS+ Do not use the SteamVac carpet cleaner as a dry vacuum cleaner. Put the tool on a hard surface or against your hand to block off the suction. (See Figure 30), Align posts (C) on both ends of brush assembly with slots (D) in cleaner housing. This will only result in delay. To replace tank, do the opposite. Lower handle and replace Dirty Water Tank. Turn off and unplug the Spin Scrub. uuid:9b8eee5e-bf5b-9040-92bc-ed112feaced8 Fill Clean Water Solution Tank with HOOVER detergent (available at additional cost if not included with your model) according to instruction on page 8. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or. Do not use any type of wax with your SteamVac cleaner. Wait a few seconds (can take up to 15 seconds). 0000038756 00000 n 0000009152 00000 n PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE. Check clean solution tank also; it may need to be refilled. 6.2 Secure Dirty Water Tank lid on all sides before cleaning. 0000042861 00000 n Some models have a nozzle clean-out tool for removing debris.

D.When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). Rinsing is not necessary for cleaning, but it may improve the surfaces appearance after it is dry. If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again. Always end with dry strokes. Do not run appliance over cord. Step on the on/off handle on the left rear of the machine to power on the machine.