Use a blunt tool such as a woode

2021/05/21

Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. The Boundary Flags are visual reminders for your pet of where the Warning Zone is located.

Remove the Receiver Collar from your pet when indoors for the comfort of your pet. Using shielded cable in place of the Boundary Wire will also not cancel the signal. Please do not dispose of the unit in household or municipal waste. Once the system is set-up and ready for use, you will need to train your dog. Place battery in Receiver Collar and turn ON. 10 et le niveau de stimulation lectrostatique sur le niveau 2 ou plus. This will prevent damage to the transmitter due to surges.

During this step, do not leave your pet unattended. Make sure wires do not touch each other at the terminals.

ne donne pas la porte voulue, rglez le slecteur de longueur de fil diffremment.

Goal:To train your pet to stay in the Pet Area and respect the boundary.

0000002676 00000 n Your pet is ready for this step only when he clearly avoids the entire Static Stimulation Zone, regardless of any distractions or temptations. Insert the stripped ends into the wire connector and twist the wire connector around the wires. CAUTION: To prevent an unintended stimulation, after the Boundary Flags have been placed, be sure to set the Static Stimulation on the Receiver Collar back to level 1 Tone Only.

For best results, brush away dirt or other debris before patching. Check your garden to determine any possible damage to the Boundary Wire (e.g.

Obey all safety messages that follow this symbol to avoid possible injury or death. Twisting two sides of the Boundary Wire cancels the signal and allows your pet to cross over that area safely. To Attach the Boundary Wire to an Existing FenceThe Boundary Wire of the Little Dog Deluxe In-Ground Fence can be attached to a chain link fence, split rail fence, or a wooden privacy fence. Be sure to always wear your safety goggles. To activate the collar, insert the battery module (5A).

0} s:N& 1&^q,6*#'y|QuMh&4]XB:yL.3TLM%,vgJm1,}\AAS

Begin by walking your pet on a lead in the Pet Area.

The Perimeter Loop is the most common layout. Double Loop with an Existing Fence: Run Boundary Wire on top of the fence and return it on the bottom of the fence to get the 1.5 m (5 ft) separation needed. Below is a chart explaining the various correction settings available and their respective indicators: The PIF-300 comes with a PetSafe 6 volt RFA-67 battery, which will last for up to 3 months of use and costs less than $4 a piece. Use the Fence Transmitter indoors in a dry location only. This is called bed sores; it is also called decubitus ulcers or pressure necrosis. 0000010376 00000 n

Pushing the Stimulation Level Button while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1.

You can buy as many collars as you need at an average of $90/collar and they will all work perfectly fine.

Place the Receiver Collar on your pet so that the battery module is pointing down. 0000012423 00000 n

Ranging from redness to pressure ulcers; this condition is commonly known as bed sores.

For example, if the signal is detected 3 metres from the wire and your dog enters the Static Stimulation Zone, this feature is activated when he is approximately 2.4 metres from the Boundary Wire. If the condition persists beyond 48 hours, see your veterinarian. Requte la plus frquente dans le dictionnaire franais: Proposer comme traduction pour "boundary width". Petsafe system installation manuals are all available at the bottom of this page.

Some pets are sensitive to contact pressure.

Stay at the same flag until your pet resists going into the Static Stimulation Zone. Use this to find the exact locations where the boundary flags should be inserted for training your dog with visual cues.

The receiver collar will fit any dog with a neck size of 6 to 23.

Run Through PreventionThis system includes a unique run-through prevention so that your dog cannot escape the Pet Area without receiving an increased level of Static Stimulation. It is important that you reinforce training with your pet on a regular basis.

Place the Test Light Tool Contacts on the Contact Points on the Receiver Collar (.

If redness or sores are found, discontinue use until the skin has fully healed. Training should be fun, fair, firm and consistent. Throw a ball or treat outside of the Pet Area. Set the Boundary Width Control Switch (located on the side of the Fence Transmitter), The width of the containment field is adjusted using the transmitters Boundary Width. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

It is designed to startle, not to punish.

Work carefully.

l'intrieur du cble et l'autre moiti l'extrieur du cble. Underground cables can carry high voltage. Check the regulations in your area before discarding spent batteries.

Twisting the Boundary Wire cancels the signal and allows your pet to cross over that area safely (3B).

Your email address will not be published. Proper fit of the collar is important.

This will make any layout changes easier.

If using a Double Loop with an existing fence at least 1.5 m (5 ft) tall, run the Boundary Wire on top of the fence and return it on the bottom of the fence to get the 1.5 m (5 ft) separation needed.

Goal:To give your pet free run of the Pet Area off the lead. The Static Stimulation will get your pets attention, but will not cause harm. Put a separate non-metallic collar on your pets neck ABOVE the Receiver Collar and attach a lead.

Test the receive collar with the test light walking toward the boundary wire. Twist the Boundary Wire 30 to 36 times per metre (10 to 12 times per foot) to cancel the signal.

If the storm is close enough for you to hear thunder, it is close enough to create hazardous surges. Spend at least 5 minutes of play time at the completion of each session within 3 m (10 ft) of the Boundary Flags.

0000010542 00000 n

While rare, if this occurs your Boundary Wire is probably too close to these outside lines and should be moved or modified as shown in Figure, To test the run-through prevention feature, walk towards the Boundary Wire.

Keep in mind that how much further you extend the boundary with each turn of the knob will depend on whether you have set the signal strength switch to LOW or HIGH.

Walk your pet out of the Pet Area while giving a command such as OK at a specific place of the Boundary Zone (the end of your driveway, sidewalk, etc.). distance of the first wheel mark (tramline) from the field's boundary.

Comment document.getElementById("comment").setAttribute("id","a83f5407d2aac3061d47753ba30dcbd8");document.getElementById("afe6277d1c").setAttribute("id","comment"); Save my name, email, and website in this browser for the next time I comment. Program the Static Stimulation Level on the Receiver Collar to level 2 or higher depending on the reaction results from days 2 thru 4.

Some pets are sensitive to contact pressure.

For alisting of Customer Care Centre telephone numbers, visit our website at www.petsafe.com. Ensure that the wire connector is secure on the wire splice. Check that it activates at the Boundary Wire. 6

It might also be a good idea to use pliers to attach and remove the probes.

Locate the halfway point of your boundary and cut the Boundary Wire.

V900p}b`SfK| %$j3x5B'SO#7' 54Re8_E@n yc_Nu+wWr-q?J0( e0 endstream endobj 293 0 obj 671 endobj 258 0 obj << /Type /Page /Parent 242 0 R /Resources 262 0 R /Contents [ 267 0 R 269 0 R 271 0 R 273 0 R 275 0 R 277 0 R 281 0 R 283 0 R ] /BleedBox [ 0 0 612 792 ] /TrimBox [ 0 0 612 792 ] /Thumb 196 0 R /MediaBox [ 0 0 612 792 ] /CropBox [ 0 0 612 792 ] /Rotate 0 /ID 291 0 R >> endobj 259 0 obj << /Count 2 /Type /Outlines /First 260 0 R /Last 260 0 R >> endobj 260 0 obj << /Title (petsafecia.com) /Parent 259 0 R /First 261 0 R /Last 261 0 R /Count 1 >> endobj 261 0 obj << /Title (400-662) /Dest [ 258 0 R /XYZ 0 792 null ] /Parent 260 0 R >> endobj 262 0 obj << /ProcSet [ /PDF /Text ] /Font << /F1 263 0 R /F2 279 0 R >> /ExtGState << /GS1 288 0 R /GS2 286 0 R /GS3 287 0 R >> /Properties << /MC1 290 0 R >> >> endobj 263 0 obj << /Type /Font /Subtype /Type1 /FirstChar 30 /LastChar 174 /Widths [ 677 0 278 344 555 668 521 917 781 278 417 417 510 667 344 458 344 278 521 521 521 521 521 521 521 521 521 521 344 344 667 667 667 458 930 781 781 802 875 750 686 844 875 406 406 781 686 1010 792 875 729 865 771 656 740 833 729 1031 781 729 686 396 278 396 581 500 333 561 604 521 615 521 354 552 625 333 313 552 311 979 625 573 615 615 479 458 375 625 542 771 552 542 510 394 588 394 520 351 0 351 0 0 0 0 0 0 0 0 0 0 0 351 0 351 351 0 344 0 0 351 0 0 0 1000 0 0 0 351 0 0 278 0 521 510 0 0 0 0 0 747 0 0 0 458 747 ] /Encoding 265 0 R /BaseFont /BKPKBB+Plantin-Bold /FontDescriptor 264 0 R >> endobj 264 0 obj << /Type /FontDescriptor /Ascent 696 /CapHeight 682 /Descent -188 /Flags 262178 /FontBBox [ -84 -250 1153 934 ] /FontName /BKPKBB+Plantin-Bold /ItalicAngle 0 /StemV 144 /XHeight 450 /StemH 47 /CharSet (/P/e/t/S/a/f/registered/space/I/n/hyphen/G/r/o/u/d/R/i/F/c/trademark/O/p\ /g/T/l/s/h/b/one/eight/zero/seven/three/two/six/underscore/C/w/period/m/\ B/y/five/A/W/N/L/v/slash/parenleft/parenright/V/D/H/Y/M/k/K/colon/Z/J/co\ mma/bullet/U/E/x/fi/quotesingle/four/quoteright/nine/z/quotedbl) /FontFile3 284 0 R >> endobj 265 0 obj << /Type /Encoding /BaseEncoding /WinAnsiEncoding /Differences [ 19 /Lslash /lslash /minus /fraction /breve /caron /dotlessi /dotaccent /hungarumlaut /ogonek /ring /fi /fl ] >> endobj 266 0 obj 3189 endobj 267 0 obj << /Filter /FlateDecode /Length 266 0 R >> stream

Put your pet in a car that is within the Pet Area and drive him out of the Pet Area.

Be sure to discard the used battery properly. Do not install, connect, or remove your system during a lightning storm.

0000004004 00000 n

With the battery installed, press the Stimulation Level Button and release when the Receiver, The Receiver Indicator Light will emit a number of red flashes representing the Static. Important Recycling AdvicePlease respect the Waste Electrical and Electronic Equipment regulations in your country.

CAUTION: The Receiver Collar should NOT be on your dog when the system is tested. notice.style.display = "block"; function() {

You may find after some time that your pet is very tolerant of the collar.

This will prevent damage to the Transmitter due to surges. setTimeout( ACMAThis device complies with the applicable EMC requirements specified by the ACMA (Australian Communications and Media Authority).

NOTICE is used to address practices not related to personal injury.

Remove the twisted wire from the Fence Transmitter Boundary Loop terminals by pushing the red release levers on the connector and pulling the wires free.

Contact the Customer Care Centre or visit our website at www.petsafe.com to locate a retailer near you.

CAUTION: The receiver collar should not be on your dog when the system is tested.

+ CAUTION: Never leave the Receiver Collar on your pet for more than 12 consecutive hours.

Save Boundary Flags for future use.

Be sure to discard the used battery properly. For the Petsafe Stubborn Dog fence system's manual click here.

0000002606 00000 n

0000004114 00000 n When possible reposition the collar on the pets neck every 1 to 2 hours.

Should your pet escape, take the Receiver Collar off and lead him back into the Pet Area. 0000018193 00000 n

While replaceable batteries are not as convenient as a rechargeable receiver, they do have a significant upside: if the battery were to malfunction, you can replace it manually this is not possible on a rechargeable receiver, as they come with built-in batteries which can only be removed by an authorized service representative. Note: You may also carry your pet out of the Pet Area. Measure and cut a Test Wire which is half the length of your total Boundary Wire footage. There are a total of 6 correction levels available: 1 is the beep-only, and the other five are a beep plus one of five static correction intensities. Anchor one end of the wires to something secure and insert the other end in a power drill. Dogfence.ie is an official distributor of Petsafe & Innotek Radio Fences, Wired & Wireless dog systems, Dog training Collars and other Dog Training and containment items, Address:6 Blyry Ct, Blyry Industrial Estate, Athlone, Co. Westmeath. 0000009488 00000 n 0000007364 00000 n Millions of pets are comfortable while they wear stainless steel contacts.

Contact the Customer Care Centre for assistance. This is the safety alert symbol.

If its short and thin, use the shorter ones. If separating the wire by at least 3 m (10 ft) from a neighbouring containment systems wire does not reduce the inconsistent signal, contact the Customer Care Centre.

Sitemap 64

- le creuset enameled cast iron safe

preserved eucalyptus branches