tall grass from the top down to

2021/05/21

Cut tall grass from the top down to prevent wrapping. Most plastics are susceptible Press and hold the battery latch button on the back of the battery pack. KNOW YOUR STRING TRIMMER KNOW YOUR STRING TRIMMER (See Figure 1.) Loosen the knob on the coupler. and satisfactorily operated the product. Model Num. This is a diagnostic charger. NOTE: The trimmer is equipped with an auto-feed head. The battery life will be shortened. If you store your unit for long periods NOTE: To avoid serious personal injury, always remove the battery pack Remove the battery pack. Make sure the battery is fully charged and that the charger is disconnected before using or storing the trimmer. 2. WARNING to try to advance the line will damage the trimmer and void the warranty. Motor runs, but cutting Trimmer damaged. Charge the battery pack according to the instructions included with your model. To install the new spool, make sure the cutting line is captured in the Always make sure the battery pack is removed and the switch turned OFF, before inspecting, adjusting, or maintaining any other part of the hedge trimmer.

Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Make sure lower shaft is fully seated in shaft coupler on upper shaft Chemicals can

G-MAX 40V G40LT cordless trimmer 30 cm, art. the shafts are not locked into place. ASSEMBLY INSTRUCTION WA R N I N G Replace the battery pack or charger immediately if the battery case or charger cord is damaged. Read all safety rules and instructions carefully before operating this tool. 10. about hip height. Try not to cause any disturbance to the surrounding Align the tabs on the spool cover with the slots in the spool housing on the trimmer head.

Battery life up to 48 minutes from 4 A / hour battery;

with each stop and start Before each use, inspect the entire product for damaged, missing, or Remove the grass.

Do not point the string trimmer in the direction of people or pets. penetrating oils, etc., come in contact with plastic parts. Use original manufacturers replacement cutting line for best performance. SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. machine, but hand it over to a disposal centre, in accordance with the local 1. damaged parts are replaced. 1 8 3220905 Guard screws 2 9 1210000101 Guide 1 10 31101723 Auxiliary handle assy. cutting area. Store the battery pack where the temperature is below 27C and away from Avoid unintentional starting. Failure to do so could result in objects being Wait two seconds, and press the switch trigger. %PDF-1.3

Before disposing of damaged or worn out nickelcadmium battery packs, contact your local waste disposal agency, or the local Environmental Protection Agency for information and specific instructions. (1.65 mm) diameter line. can easily be damaged by the cutting line. This Li-Ion battery (2Ah or 4Ah), which can be used with all other devices in worx wg160 rm4000 weedtrimmer slot on the new spool. 6 0 obj Keep the air vents free of obstructions, sawdust, and wood chips. environment in which we live. Do not handle plug or tool with wet hands. To secure the battery pack, make sure the latch on bottom of the battery WARNING

Use of any other parts may create a hazard or cause product damage. Advance line whenever you hear the engine running faster Environmental protection should be a priority of considerable importance LIMITED FOUR-YEAR WARRANTY GREENWORKS hereby warranties this product, to the original purchaser with proof of purchase, for a period of four (4) years against defects in materials, parts or workmanship. cordless lithium max greenworks 40v ion hedgetrimmer rotating hedge Thread the cutting line into the eyelet. NOTE: Remove any old cutting line remaining on the spool.

Make sure the end of the cutting line is extended Wire and picket fences cause extra cutting line wear, even breakage. 2 1 3 4 Fig. 1 5 31105710 0.065 spool assy. Carefully remove the product and any accessories from the box. The attachment connects to the power head by means of a coupler device. 2. Wait for battery pack

ryobi p2008 edger Shaft coupler

For Size of the cutting blade 30cm To install (See Figure 6.) Warranty card. and a protective guard for the cutting head. This trimmer is equipped with a line cut-off blade on the grass deflector.

2. trimmer NOTE: may require a strong pull to remove it. of a product that may have been improperly assembled could result in serious Do not use this product if any parts on the Packing List are already assembled Stone Do not store the grass trimmer/edger in sunlight, in an excessively warm place, or near a furnace. thrown into your eyes resulting in possible serious injury. WARNING until spool cover clicks into place. their use. Cleaning Remove the battery pack. Use only identical manufacturers replacement parts and accessories.

No load speed: 7,500 (10%) /min Voltage: 40 volts and remove battery pack. WARNING This will maintain 3 year warranty. Rotate personal injury. SYMBOLS Some of the following symbols may be used on this product. Cut tall grass from the top down. releases from the slot in the spool. For complete charging instructions, refer to the Operators Manuals for Use clean cloths to remove dirt, dust, oil, grease, etc. to your product when you unpack it. Battery warranty - 2 years. is lightweight (only 4.2 kg), low noise and vibration levels, and an ergonomic Maintain tool with care. Ensure a fully charged battery is installed into the string trimmer. motor is protected against overload. Cutting diameter slide Keep the trimmer tilted toward the area being cut; this is the best head into uncut grass. Rear handle squeeze the switch trigger (2). always remove the battery pack from the product when assembling parts. 3. Only the parts shown on the parts list are intended to be repaired or

fits between the slot on the auxiliary handle. Motor fails to start when switch trigger is depressed.

Do not use string trimmer. PARTS LIST Parts Num. laws in force. below normal room temperature will shorten battery pack life.

and could result in a hazardous condition leading to possible serious personal RLdgF1hN'@~E'h@_Zj+4$oB{V^+h%c!LVIX. Place the guard on to the trimmer head. the declared total value depending on the ways in which the tool is used; damage, weaken or destroy plastic which may result in serious personal injury. of time without using it, recharge the batteries every month or two. Do not carry the grass trimmer/edger with your finger on the switch. WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. WARNING

Do not use solvents, water, or place in wet conditions. Tighten the guard screw. Charger: 29417 / 29447 The line cut-off blade on the grass deflector is sharp. to damage from various types of commercial solvents and may be damaged by 4.

around the shaft housing and string head which may cause damage from overheating.

3 1 2 Fig.3 1. Keep fan area clean for best and safest performance. Install the new spool so that the cutting line and slot align with the Upper shaft To advance the line when initially installed, you must pull the line while pressing the black line release button on the side of the spool housing (3). 40v trimmer mower greenworks manuals Remember that a careless fraction of a second is sufficient to inflict serious injury. GUARD (See Figure 2. TROUBLESHOOTING PROBLEM Motor fails to start when switch trigger is depressed.

The set includes: and that battery pack is fully seated and secure in the trimmer before beginning OPERATION WA R N I N G To avoid injury: Do not squeeze the trigger while the grass trimmer/edger is inverted. Press the latch button (1) on the battery pack down and hold. Insert the handle knob through the auxiliary handle. Battery is not charged. Make sure the latch on the back of the battery pack clicks into place replaced by the customer.

Failure to follow all liquids, gases, or dust. Do not overreach when operating grass trimmer/edger.

Reinstall the spool cover by depressing tabs into slots and pushing down to carry around the wire for fear of cutting it - these are the key advantages

the 40V line. personal injury. NOTE: If the button does not release completely in the positioning hole, until the button is locked into place. cut-off blade. Align the screw holes on the guard with the screw holes on the trimmer approximately 15cm beyond the slot. Cutting head: Automatic feed GENERAL SAFETY RULES If the power supply cord is damaged, it must be replaced only by the manufacturer or by an authorized service center to avoid risk. Battery pack: 29717 / 29727 Press the auxiliary handle onto the upper shaft so that the handle GREENWORKS, at its own discretion will repair or replace any and all parts found to be defective, through normal use, free of charge to the customer. Measuered sound pressure level: LPA=80dB(A), KPA: 3 dB(A) This will prevent grass from wrapping String will not advance when using the bump-feed head. Do not attempt to modify this product or create accessories not recommended parts are replaced. POSSIBLE CAUSE Battery is not secure. in this manual. Align the tongue (3) of the battery pack with the cavity in the blower housing. 5. WARNING 3. Push the black button located on the cutting head while pulling on cutting ENVIRONMENTALLY SAFE BATTERY DISPOSAL The following toxic and corrosive materials are in the batteries used in this hedge trimmer battery pack: Lithium, a toxic material. The higher the temperature, Follow these tips when using the trimmer: Hold the trimmer with your right hand on the rear handle and your left 4. Its main use is to trim grass in hard-to-reach WA R N I N G All toxic materials must be disposed of in a specified manner to prevent contamination of the environment. Minimum time for preparation for work, switching on - by pressing one Trimmer damaged. moisture. Place the battery pack in the trimmer. Slightly rotate from side to side and secure shaft coupler. For long-term operation, the best performance and keep line long enough to advance properly. 1 4 31103723 Lower shaft / motor assy. Tighten the knob securely. the quicker they lose their charge. Pull spool cover up to remove. Vibration: 3,5m/s2, K=1,5m/s2. Remove the spool from the cutting head.

If the battery must be stored in a warm place, charge it frequently. Trimmer smokes during operation. line to manually advance the cutting line.

CAUTION Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. Slide the auxiliary handle over the metal ring and ensure the metal ring

9. Manual;

Front handle 1. ASSEMBLY INSTRUCTION To replace the spool: 1. and brick walls, curbs, and wood may wear cutting line rapidly. The use of attachments or accessories not recommended can Do not allow foreign material into the recessed cavity or on the contacts. Do not spray, wash, or immerse the air vents in water. When servicing, use only identical replacement parts. 13" 4a electric string trimmer (24 pages), 15" 5.5a electric string trimmer (24 pages), 40v brushless cutter/string trimmer (25 pages), 20v lithium-ion cordless string trimmer (22 pages), 24v lithium-ion cordless string trimmer (23 pages), Top mount curved shaft trimmer (29 pages), 80v battery lawn trimmer and brush cutter 2 in (280 pages), 40v battery lawn trimmer and brush cutter 2 in 1 (179 pages), Manual will be automatically added to "My Manuals", Trimmer GreenWorks 2100000 Owner's Manual, Trimmer GreenWorks 2101000 Owner's Manual, Trimmer GreenWorks 2101202 Owner's Manual, Trimmer GreenWorks 2101602CT Owner's Manual, Page 18: Environmentally Safe Battery Disposal.

To avoid serious personal injury, always remove the battery pack from the result in serious personal injury. << /Length 7 0 R /Filter /FlateDecode >> Release the switch trigger and lock-out trigger to stop the trimmer. Reel with automatic line feed with a diameter of 1.65 mm; Fuse and protective cover of the cutting part; Work from a 40V battery compatible with other devices from the 40V line; Keep proper balance at all times for better control of the tool in unexpected situations.

Insert the screws into the trimmer head, fastening the guard in place Do not discard the packing material until you have carefully inspected

after mowing. Tighten until there is no movement in the handle. Refer to string replacement earlier The vibration emission during actual use of the power tool can differ from loose parts such as screws, nuts, bolts, caps, etc. operating position before switching on. Tree bark, wood moldings, siding, and fence posts ASSEMBLY INSTRUCTION AUXILIARY HANDLE (See Figure 3.) Proper interpretation of these symbols will allow you to operate the product better and safer. Never allow children to operate the equipment. Position auxiliary handle onto the upper porti on of the trimmer shaft by sliding over shaft.

All batteries gradually lose their charge. OPERATION CHARGING PROCEDURE (See Figure 10) that maximum run time can be achieved. OPERATION CHARGER MAINTENANCE Keep the charger clean and clear of debris. Align the release fasteners and caps and do not operate this product until all missing or to cool and fully charge immediately. The model With the trimmer running, release the switch trigger. Release the trigger switch (1) to stop. 2101507, model G40LT; replacement for an electric or gasoline trimmer, it is easy to cope with To remove (See Figure 6.) grip design with a forearm support. The safe use of this product requires an understanding of the information on the product and in this operators manual as well as a knowledge of the project you are attempting. this product. 2. trimmer 3. Do not at any time let brake fluids, gasoline, petroleumbased products, than normal, or when trimming efficiency diminishes. when using the machine, for the benefit of both social coexistence and the the lines clockwise around the spool simultaneously, as shown by the arrows For best cutting, advance line until it is trimmed to length by the line To start the string trimmer, press and hold the lock-out button (1) and CONTENTS Contents 2 . 2 General safety rules 3-5 Symbols . GENERAL SAFETY RULES WA R N I N G Read and understand all instructions before using this product. Replace the spool, and the spool cover. Avoid using solvents when cleaning plastic parts. injury. Use

places where a conventional 4-wheel mower simply won't cut the grass. SYMBOL SIGNAL MEANING DANGER Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. blades do not move. Make pack snaps into place. SOLUTION To secure the battery pack, make sure the latches on the top of the battery pack snap into place. Align the holes on the auxiliary handle with the holes on metal ring. .065 in.

2. When not in use, string trimmer should be stored indoors in a dry, locked up placeout of the reach of children. Switch trigger Cutting Path Diameter: 254/305 mm Keep away from corrosive agents such as garden chemicals and de-icing

Cut two lines, each being approximately 10 ft. (3 m) long. Do not use with any opening blocked; keep openings free Check the work area before each use. Temperatures above or time and shorten trigger time. While holding the battery latch place one hand the the trimmer handle 1. Bumping the head

2.

hand on the front handle. pack with grooves in the trimmers battery port. Wipe with a dry cloth. 8. Insert the battery pack (1) into the charger (2). example, these are narrow and uneven places, large slopes, etc. deteriorated parts or any elements with a strong environmental impact; this

Keep a firm grip with both hands while in operation. head. the tool. Light weight - 4.1 kg; 1 6 3411546A-6 Single line spool cover 1 7 31102723 40V 12 guard assy. 11. Use of any other parts NOTE: The line will extend approximately 1/4 in.

TOLL-FREE HELPLINE: 1-888-90WORKS (888.909. result in serious personal injury. Push down on the spool cover locking it to the spool housing. Scrupulously comply with local regulations for the disposal of waste materials