makita lawn mower blade change
WARNING: Always turn off the main power switch when not in use. When you use the machine on the muddy ground, wet slopes, or slippery places, pay attention to your footing. ), Insert the pin into the hole, and then hold the handle with. Pull up the locking lever and open the battery cover. Please also observe possibly more detailed national regulations.
Part No. Check with local codes for possible special disposal instructions. Always stop tool operation and charge the battery cartridge when you notice less tool power. Stop operation immediately if you notice anything unusual. Do not put hands or feet near or under rotating parts. Walk, never run. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Use of a cord suitable for outdoor use reduces the risk of electric shock. Such preventive safety measures reduce the risk of starting the power tool accidentally.
WARNING: Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Follow instructions for lubricating and changing accessories. Keep all cooling air inlets clear of debris. Lift up the mulching plug slightly, and then remove it. Remove any adjusting key or wrench before turning the power tool on. NOTE: The mower does not start without pressing the switch button even the switch lever is pulled. Take all the following steps to clear the causes, when the machine has been brought to a temporary halt or stop in operation. Indicating the remaining battery capacity. WARNING: To reduce a risk of accident, regu-larly check the grass basket for any damage or weak-ened strength. It has a top/bottom facing. Make sure that the knobs are securely fixed. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. This will ensure that the safety of the power tool is maintained. Remove the bolt, washer, mower blade, and bracket in order. Thoroughly inspect the area where the lawn-mower is to be used and remove all stones, sticks, wires, bones, and other foreign objects.
When the grass basket is almost full, the indicator does not float while the blades are running. The main power lamp lights up in green. This system automatically cuts off power to the motor to extend machine and battery life. Use of any other battery packs may create a risk of injury and fire. The traveling speed can be adjusted with the speed lever. If the cord is damaged, the mower switch may not work. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury. NOTE: If the main power lamp lights up in red or blinks in red or green, refer to the instructions for machine/battery protection system. Close the battery cover and push it until it is latched with the locking lever. It may result in loss of your eyesight. Caution Blades coast after the mower is switched off. Sound power level according to Australia NSW Noise Control Regulation. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Before asking for repairs, conduct your own inspection first. Overlap by one half to one third the previous strip to mow the lawn evenly. The distance between the tool and bystanders must be at least 15 m. Never put your hands and feet near the blade under the mower. Use the batteries only with the products specified by Makita. The cell may explode. Charge the battery cartridge with room temperature at 10 C 40 C (50 F 104 F). Turn the bolt counterclockwise with box wrench. Align the tongue on the battery cartridge with the slot on the machine, and then slide the cartridge until it locks in place with a little click. Replace worn or damaged parts for safety. Never remove or tamper with safety devices. Liquid ejected from the battery may cause irritation or burns. Failure to remove the lock key and the battery cartridge may result in seri-ous personal injury from accidental start-up.WARNING: Never start the mower unless it is completely assembled. Contact with water can cause electric shock. When you operate the machine with the mulch-ing plug, be sure to remove the grass basket. The followings show the symbols which may be used for the equipment. If the mower strikes a foreign object, follow these steps: Do not start the mower when standing in front of the discharge opening. Do not overreach. If the terminal gets wet or liquid enters inside of the battery, the battery may be short-circuited and there is a risk of overheating, fire, or explosion. Prevent unintentional starting. If damaged, have the power tool repaired before use. Washer 4. Bracket 3. Always ensure that both hands are in the operating position before returning the mower to the ground. Service of battery packs should only be performed by the manufacturer or authorized service providers. When storing the machine, avoid direct sunlight and rain, and store it in a place where it does not get hot or humid. WARNING: Always wear gloves when han-dling the blade.
This mower is equipped with the lock key and handle switch. Bolt, Manual will be automatically added to "My Manuals", Lawn Mower Makita ELM3311 Original Instruction Manual, Lawn Mower Makita ELM3711 Original Instruction Manual, Lawn Mower Makita ELM3800 Original Instructions Manual, Lawn Mower Makita ELM4110 Original Instruction Manual, Lawn Mower Makita ELM3310 Original Instruction Manual, Lawn Mower Makita ELM3300 Operator's Manual, Lawn Mower Makita ELM4100 Operator's Manual, Lawn Mower Makita ELM4610 Original Instruction Manual, Lawn Mower Makita ELM4612 Original Instruction Manual, Lawn Mower Makita ELM4121 Instruction Manual, Lawn Mower Makita ELM4121 Series Instruction Manual, Lawn Mower Makita EM2651LH Instruction Manual. NOTE: This machine employs the auto power-off function. NOTICE: When installing the mower blade, make sure that the protrusions on the blade support fit in the holes in the mower blade. The handle height can be adjusted in two levels. Dry the battery cartridge completely in a dry place before use. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. Always ensure that the ventilation openings are kept clear of debris. Avoid using the mower in bad weather con-ditions especially when there is a risk of lightning. Power tool plugs must match the outlet. It may be toxic if swallowed. The center lines of the front wheels are guidelines to mowing width. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING: Make sure that the mower blade and all the fixing parts are installed correctly and tightened securely. Released electrolyte is corrosive and may cause damage to the eyes or skin. Save all warnings and instructions for future reference.Training. In this situation, turn the machine off and stop the application that caused the machine to become overloaded. Do not use any adapter plugs with earthed (grounded) power tools. Empty the grass before it becomes full. Do not operate the mower when barefoot or wearing open sandals. The use of dust collection can reduce dust-related hazards. Pouring water to the motor unit may cause a malfunction of the machine. Replace a worn grass basket with a new factory replacement for safety. Using the center lines as guidelines, mow in strips.
The machine will automatically stop during operation if the machine or battery is placed under one of the fol-lowing conditions: Overload protectionWhen the battery is operated in a manner that causes it to draw an abnormally high current, the machine automatically stops and the main power lamp blinks in green. If recharging is not effective, replace battery cartridge. Stop the blade(s) if the mower has to be tilted for transportation when crossing surfaces other than grass, and when transporting the mower to and from the area to be used. Recharge only with the charger specified by the manufacturer. WARNING: Always remove the lock key and battery cartridge when removing or installing the blade. Operate the mower only in daylight or in good artificial light. Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. Keep cutting tools sharp and clean. Keep handles and grasping surfaces dry, clean and free from oil and grease. Mowing long lawnDo not try to cut long lawn all at once.
If the mower starts to vibrate abnormally. Do not operate the lawnmower when barefoot or wearing open sandals. Warning; Disconnect battery before maintenance. In this case, let the machine and battery cool before turning the machine on again. The table below shows the relationship between the number on the mower body and the approximate mow-ing height. This decreases the risk of being struck by lightning. Intended useThe machine is intended for lawn mowing. Do not insert the lock key into mower until it is ready to be used. Pull out the battery cartridge from the machine while sliding the button on the front of the cartridge. Inspect and maintain the mower regularly. Ensure the switch is in the off-position before connecting to a power source and/or battery pack, picking up or carrying the tool. Do not handle chargers, including charger plug, and charger terminals with wet hands. Electrical hazard. Open the upper clip, and attach it to the frame. NOTICE: Be careful not to pinch the cords when folding the handle. Stop the mower and remove the lock key, and make sure that all moving parts have come to a complete stop: Never operate the mower with defective guards or shields, or without safety devices, for example deflectors and/or grass basket, in place. If the machine is in the upright position, water may pour down the motor unit, and cause a malfunction of the machine. Exposure to fire or temperature above 130 C may cause an explosion. If contact accidentally occurs, flush with water. Shut the motor off and wait until the blade comes to a complete stop before removing the grass catcher. Be sure that you understand their meaning before use. Never direct discharged material toward anyone. It will also void the Makita warranty for the Makita tool and charger. In this situation, charge the battery cartridge. Do not mow exces-sively steep slopes. There is an increased risk of electric shock if your body is earthed or grounded. Spacer 2. Do not disassemble or tamper with the battery cartridge. When disposing of the battery cartridge, remove it from the tool and dispose of it in a safe place. Insert the lock key, and then close the battery cover. Loose clothes, jewelry or long hair can be caught in moving parts. Never recharge a fully charged battery cartridge. The mowing speed guideline is approximately 7 to 14 meters per 10 seconds. Do not wear loose clothing or jewelry. Never service damaged battery packs. Two battery cartridges are not installed. If liquid contacts eyes, additionally seek medical help. WARNING: The blade coasts for a few sec-onds after releasing the switch. For storage, always make sure the grass basket is empty. When the remaining battery capacity gets low, the bat-tery indicator blinks on the applicable battery side. Blade is imbalanced, excessively or unevenly worn. The goggles must comply with ANSI Z87.1 in the USA, EN 166 in Europe, or AS/NZS 1336 in Australia/New Zealand.
Maintain power tools and accessories. Battery cartridge is installed improperly. While operating the lawnmower, always wear long trousers. NOTICE: When using the machine with the mulching plug, make sure that the total length of grass after cutting is 30 mm or more, and the cut length is 15 mm or less. Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges, and refrigerators. WARNING: Always wear the safety goggles or safety glasses with side shields when performing inspection or maintenance. Check the grass basket frequently for wear or deterioration. This reduces the risk of loss of control, slipping and falling which may result in personal injury. Such conduct may result in a fire, excessive heat, or explosion.
Store the lock key in a safe place out of reach of children. WARNING: Only use the battery cartridges and chargers listed above. NOTE: Try a test mowing of grass in a less conspicu-ous place to get your desired height. Keep hands and feet away from rotating blades. Remove the lock key and battery cartridges, and then close the battery cover.
When using the tool, do not wear cloth work gloves which may be entangled. Using mulching plugThe mulching plug allows you to return the cut grass to the ground without gathering the cut grass in the grass basket. Mower blade 3. Let a hot battery cartridge cool down before charging it. NOTICE: Use this machine for mowing lawn only.
NOTICE: Do not pour water to the area shown in the figure. Perform the same procedure on the other side. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. Do not charge the battery in rain, or in wet locations. one hand and loosen the bolt with the wrench counterclockwise. To decrease the speed, pull the lever toward you, and to increase the speed, turn the lever forward. Charge the battery cartridge before completely discharged. Hold the lower handle, and then turn the knob 90 while pulling the knob on the lower handle to release the locking pin. WARNING: Read all safety warnings and all instructions. Overheat protectionWhen the machine or battery is overheated, the machine stops automatically and the main power lamp lights up in red. A moment of inattention while operating power tools may result in serious personal injury. Never operate the mower while people, especially children, or pets are nearby. Do not use the power tool if the switch does not turn it on and off. Stop the blade when crossing gravel surfaces. This reduces the risk of loss of control, slipping and falling which may result in personal injury. This reduces the risk of slipping and falling which may result in personal injury. Put the mower on its side so that the mowing height adjusting lever comes to the lower side. In Australia/New Zealand, it is legally required to wear a face shield to protect your face, too. It may cause heating, catching fire, burst and malfunction of the tool or battery cartridge, resulting in burns or personal injury. While holding the switch lever, push the drive lever forward and hold it to drive the rear wheels. To avoid unintentional start up, the main power switch will automatically shut down when the switch lever and drive lever (if equipped) are not pulled for a certain period after the main power switch is turned on. When not using the battery cartridge, remove it from the tool or the charger. Specifications may differ from country to country. Replace cracked or damaged blades or blade bolts immediately. Depending on the conditions of inside of the basket, this indicator may not work properly. Use personal protective equipment. Put the mower on its side. Then turn the machine on to restart. Have your power tool serviced by a qualified repair person using only identical replacement parts.
- Brass Wholesale Market In Pune
- The Ridge Leather Keychain
- Nabisco Nutter Butter Cookies
- Ted Baker Phone Case Iphone 13
- Plexiglass Heater Bender
- Best Office Chair Mat For Tile Floors
- 2-in-1 Vacuum And Steam Cleaner
- Commercial Smoke Eater
- 6 Pack Styrofoam Cooler
makita lawn mower blade change 関連記事
- 30 inch range hood insert ductless
-
how to become a shein ambassador
キャンプでのご飯の炊き方、普通は兵式飯盒や丸型飯盒を使った「飯盒炊爨」ですが、せ …